Step 3 - Replace the parking brake motor. The motor is connected to the back of the brake caliper, one on each rear wheel. To replace it, remove the two T30 Torx screws holding it in place, then disconnect the harness. Use a 6mm bit to turn the caliper and retract the piston fully. Set the new motor in place and replace the T30 screws, then
My car is Audi A6 C6 BPP 2005, but it could be the same issue on A3,A4,A7,A8 etc.So about my problem:Sometimes when I tried to unlock the car the fob did not The Audi A6 is an executive car made by the German automaker Audi. Audi unveiled a facelifted "C6" Audi A6 on 12 August 2008, Electric power is supplied via a 1.3 kWh lithium-ion battery, with electric-only range of 3 km for constant 60 km/h (37.28 mph) drive and a top speed of 100 km/h (62.14 mph).Vehicle Power Control Module. Fits A6 (2012 - 2015) CONTROL MODULES, onboard power supply unit, onboard power supply unit. SUPPLY CONTROL MODULE, from 02/18/2012. SUPPLY CONTROL MODULE, to 02/17/2012. 2 people have looked at this part recently. Diagrams and Kits.Location: Melton Mowbray. Audi Model:: A6. Audi Year: 97. Posted April 15, 2021. So I suffered a typical ignition fault in that my car wouldn't switch off on removal of the key. Lots of reading pointed to new switch being needed. So found one same year on eBay with all the same code bar one difference mine is 0.8 the new one is 0.7. . 643 0 630 562 28 16 55 772